How to Replace Your Tesla Badge with FELON | Step-by-Step Install Guide
Share
Installing your FELON badge is simple, clean, and fully reversible.
Designed to replace your factory emblem with minimal tools and no damage, this upgrade takes less than 15 minutes — and leaves a lasting impression.
Here’s how to do it right.
Step 1: Mark Your Alignment
Place painters tape beneath the old logo before removing it — or use a levelled guide to line things up. Trust us, your future self will thank you.
Step 2: Remove the Old Tesla Logo
-
Slide dental floss or fishing line behind the badge to lift it off cleanly.
-
If needed, gently apply heat with a hairdryer to soften the adhesive.
-
Some people use their fingernails — just go slow and keep it clean.
Step 3: Clean the Surface
-
Use rubbing alcohol to wipe down the area.
-
Remove any leftover adhesive and make sure it’s dry.
Step 4: Peel and Press
-
Remove the adhesive backing and apply your FELON badge using the included template or alignment marks.
-
Press firmly across the full surface.
Step 5: That’s It
Let it set.
Step 6: Let It Speak
A small adjustment. A quiet shift in meaning.
Need a visual guide?
👉 check out the full install guide at the bottom of our Installation Page.
Liberty Labs Co.
Made to Matter.